His shoulders were no wider than his hips; he had what is called a six o'clock figure, straight up and straight down, a skimped and scanty physique, as though the fairy of miserliness had presided over his conception.

Machining a straight spline with a lathe. Sometimes the task of splining a shaft comes up during a repair. Instead of sending out the job, use this setup to mill the splines on a lathe.

If the office copy of a Will or any part of a Will or other document is required to be made fac-simile, and such Will or part of a Will or other document is two folios of ninety words in length or under, in addition to the fee for the copy … … … … [£]0 1[s.] 0[d.] / If exceeding two folios of ninety words, for every additional folio or part of a folio … … [£]0 0[s.] 6[d.]

On the other hand, the subcategories pertinent to arachnid-produced phobias would only rarely lead to a definitive diagnosis of arachnophobia or the more specific scorpiophobia, araneophobia, or acarophobia.[…]This term, arachnophobia (fear of arachnids), has been used so often in connection with the disease condition of the Middle Ages known as “tarantism” that it has become synonymous with araneophobia (or araneidophobia). In technical reports, arachnophobia should only be used when there is assurance that the phobia is limited to all arachnids[…]. As with scorpions, these large-bodied arachnids [spiders] are spectacles of the media and currently exaggerated both as aesthetic trouble-free pets (“talk shows”) and as the central attraction in horror films. The wide distribution and overlap of habitat with animals must produce an acceleration of the number of cases of araneophobia.